24V 120W Heater Cartridge 0.2/2M DrHotSwap HotSwappable for 3D Printers

Are you always replacing your Heater Cartridge and want reduce down time on your printers? This is cost effective method where you only replace the shorter 12cm instead of running new heater cartridge or splicing wires. 

Features:

• High Quality Heater with ferrules wire extension connection to ensure reliability
• Easily to manage and flexible extension cable.
• Quick and low future replacement spare cost
• Ability to switch to higher or lower wattage heater for different hotend. [Explore Range]

Note: none/bare wire are ~17cm long

Extension Cable :

(Tested Configuration, this kit is suitable for essentially majority of Creality and other printers that use screw terminals for heater cartridge.

• 2000mm(2m)

Heater module specifications 

• Heater Length: 20mm
• Heater Material: Stainless Steel
• Heater Diameter: 6mm
• Voltage 24v DC
• Power: 120w / 120watts

Ensure your have enough peak current/power from your main board MOSFET and power supply, or you may need restrict max power draw within klipper or marlin. Ensure thermal runaway is configured and tested.

These heaters are more than capable of reaching temperatures that will soften aluminum blocks. These recommenced only be used with a copper block. Please also ensure firmware thermal runway safety  features is turn on and tested.

Note: Between batches cable extension may be red/black wiring.

Note: None (Bare Wire) does not contain molex connector for quick connection. 

OEM: DREMC